Can the slitter be used to cut melt blown cloth?

Can the slitter be used to cut melt blown cloth? The slitting machine produced by Wenzhou Haocheng Machinery Technology Co., Ltd. is used to cut all kinds of drum materials. The machine is equipped with a round knife and a straight knife to cut different materials respectively. By slitting narrow materials and materials with different difficulties, it is divided into surface winding and central winding, and longitudinal cutting is adopted. Slitting machine is a kind of mechanical equipment for cutting wide paper, mica tape or film into multiple narrow materials. It is commonly used in papermaking machinery, wire and cable mica tape and printing and packaging machinery. The slitter is mainly used for slitting mica tape, paper, insulating material and film, especially for slitting narrow band (insulating material, mica tape, film, etc.). Check the clearance between the blade holder and the nozzle bar on the left side of the wheel drum, adjust the left and right distance of the blade so that the blade can cut into the blade groove of the wheel drum. The distance between the two blades is the length of the nozzle bar to be cut: 20mm and 15mm. Tighten the screws on the blade holder to fix the blade position. Check whether all parts of the machine are loose due to transportation and other reasons, Adjust the four foot screws of the machine to verify that the machine is horizontally placed on a flat ground. Connect the external three-phase power supply, turn on the key switch placed on the operation button box, and the green light on the right indicates that the power supply has been normally connected. The black knob regulator placed on the operation button corner box controls the speed of the small puller at the upper right corner of the wheel drum, and adjust it to the speed of the small puller by turning the knob, In actual use, the knob is adjusted to the highest (clockwise) and the high-pressure gas is connected to the pressure regulating valve. The purpose of two-way gas pipe blowing is to eliminate the residual nozzle rod in the empty groove at the lower right of the wheel drum, so that the wheel drum can smoothly accept the new nozzle rod, and adjust the air pressure of the pressure regulating valve to achieve the best use effect.